Electra Elite IPK II
Document Revision 3
System Hardware Manual
6 - 153
___________________________________________________________________________________
___________________________________________________________________________________
8.4.2
Installation
Basic Port Package
Only one CCH(4)-U( ) ETU can be installed in any interface slot.
Expanded Port Package
Only one CCH(4)-U( ) ETU can be installed in any interface slot.
8.4.3
Switch Settings
Refer to
Table 6-51 CCH(4)-U( ) ETU Default Switch Settings
8.4.4
LED Indications
Refer to
Table 6-52 CCH(4)-U( ) ETU LED Indications
.
Table 6-51 CCH(4)-U( ) ETU Default Switch Settings
Switch
Setting/Description
SW1
Momentary Switch
Resets the CCH ETU. When this switch is pressed, all
K-CCIS users connected to the CCH ETU are interrupted.
Use this switch only after all other options have failed.
SW2–1
Off:
Normal Operation (Default)
On:
Test Mode
SW2–2
Off:
Boot from Flash Memory (Default)
On:
Boot from E-PROM (IC30)
SW2–3
Off:
Normal Operation (Default)
On:
Test Mode
SW2–4
Off:
Watch Dog Timer On (Default)
On:
Watch Dog Timer Off
Table 6-52 CCH(4)-U( ) ETU LED Indications
LED
Description
On
Flashing
Off
1
Link Status for
CCH1
Layer 2: Up
Not Used
Layer 2: Down
2
Link Status for
CCH2
Layer 2: Up
Not Used
Layer 2: Down
3
Link Status for
CCH3
Layer 2: Up
Not Used
Layer 2: Down
4
Link Status for
CCH4
Layer 2: Up
Not Used
Layer 2: Down
Summary of Contents for ELECTRA ELITE IPK II
