Electra Elite IPK II
Document Revision 3
System Hardware Manual
6 - 173
___________________________________________________________________________________
___________________________________________________________________________________
Table 6-67 VMP(4)/(8)-U( ) ETU Ready LED Indications
shows the
status of the VMP(4)/(8)-U( ) ETU after it has been installed,
initialized, and is ready to process calls.
8.9.5
Jumper Settings
The following jumper settings apply.
LED 17, CH8
Off/On-Hook status
Red for Off-Hook
Not Used
On-Hook
The following LEDS are also used during startup to signify:
LED 1 - BICOM driver loaded
LED 2 - Scandisk completed successfully
LED 4 - Application started successfully
After the system is up and running these LEDs are turned off, and all channels are ready to
receive calls.
When the VMP(4)/(8) fails to start, all eight channel LEDs and the BCLR LED (AP1) are on.
Table 6-66 VMP(4)/(8)-U( ) ETU LED Indications (Continued)
LED
Description
On
Flashing Off
Table 6-67 VMP(4)/(8)-U( ) ETU Ready LED Indications
LED
Description
Status
LED 1, AP1
Application Software
Running without
errors
Solid Green
LED 4, CF PWR
Power to the ETU
Solid Red
LED 5, ICGA
Live LED
Blinking Red
LED 7, Shutdown
Initialized
application
Solid Green
LED 8, Power
Receiving KSU
power
Solid Red
J1
Setting
Pin 1 to Pin 2
IVR Integration (default)
Pin 2 to Pin 3
Not Used
Summary of Contents for ELECTRA ELITE IPK II
