Electra Elite IPK II
Document Revision 3
System Hardware Manual
6 - 177
___________________________________________________________________________________
___________________________________________________________________________________
8.10.4
Applications Removal Procedure
The PVA(X)-U( ) ETU is hot swappable and can be removed from
the KTS without powering down the ETU or the Electra Elite IPK II
system.
When the Electra Elite IPK II KSU requires system reset, this ETU
comes back on line.
8.10.5
Configuring
When installed for the first time the PVA(X)-U( ) ETU comes up with
factory default settings shown in
Settings for TCP/IP Addressing
.
These parameters must be redefined before the ETU can work in
your environment. Refer to the Applicable IP Application Features
and Specifications and installation instructions.
Table 6-68 PVA(X)-U( ) ETU Configurations
Configuration
Ports
Electra Elite
IPK II
Installation slot
Application
MG16
4~16
(Increments
of four)
S1~S8
MG16 Package
IP CCISoIP
4~24
(Increments
of four)
S1~S8
CCISoIP Package
MG_CCIS
4~24
(Increments
of four)
S1~S8
Combo ETU MG16
and IP CCISoIP
CNF
8/16
S1~S8
Multimedia
Conference Bridge
Table 6-69 Default Network Settings for TCP/IP Addressing
IP Address
192.168.1.100
Subnet Mask
255.255.255.0
Default Gateway
0.0.0.0
Summary of Contents for ELECTRA ELITE IPK II
