Electra Elite IPK II
Document Revision 3
System Hardware Manual
8 - 31
___________________________________________________________________________________
___________________________________________________________________________________
4.
Turn the base cover upside down, feed the line cord through
the cutout and attach the cover to the wall using six screws as
shown in
Figure 8-39 Wall Mounting the Base Plate
.
5.
Install the Multiline Terminal over the four tabs on the base
cover, and push down until it clicks in place.
Figure 8-39 Wall Mounting the Base Plate
Figure 8-40 Installing the
Multiline Terminal
Summary of Contents for ELECTRA ELITE IPK II
