___________________________________________________________________________________
9 - 4
Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3
Electra Elite IPK II
S
ECTION
3
I
NSTALLING
A
DAPTERS
3.1
AC-2R/AC-3R Unit (AC Adapter)
This unit shown in
Figure 9-4 AC-2R/AC-3R Unit (AC Adapter)
provides power
to ancillary devices or to an Attendant Console. The AC-2R/AC-3R Unit must
be connected to some adapters that are installed on a Multiline Terminal.
When more than one adapter is installed on a Multiline Terminal, only one
AC-2R/AC-3R Unit is necessary.
The power requirements for the AC-2R/AC-3R Unit are:
J
Input: 110~240 Vac, 50/60 Hz, 45 VA
J
Output: 27 Vdc, 750 mA
J
Polarity:
3.1.1
Connecting the AC-2R/AC-3R Unit
1.
Unplug the AC-2R/AC-3R Unit from the AC outlet.
2.
Prepare Multiline Terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page 9-1
Figure 9-4 AC-2R/AC-3R Unit (AC Adapter)
⊕
Failing to do this can damage the unit and/or the
Multiline Terminal
.
Summary of Contents for ELECTRA ELITE IPK II
