___________________________________________________________________________________
9 - 16
Installing Electra Elite IPK II Optional Terminal Equipment
___________________________________________________________________________________
Document Revision 3
Electra Elite IPK II
3.3.2
Installing AP(A)-R or AP(R)-R Unit on a Multiline Terminal
The AP(A)-R or AP(R)-R Unit should be installed after the switches
are set.
When wall mounting the Multiline Terminal, a WM-R Unit must be
used. Refer to
Section 13 Wall Mounting Multiline Terminals on page
1.
Prepare Multiline Terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page 9-1
2.
Plug the tabs marked A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C
Summary of Contents for ELECTRA ELITE IPK II
