___________________________________________________________________________________
10 - 16
Installing Electra Elite Multiline Terminals
___________________________________________________________________________________
Document Revision 3
Electra Elite IPK II
2.
Push the adjustment tabs and raise the base plate until it locks.
3.
The length of the cord can be adjusted by pulling the line cord though the groove
in the bottom of the Multiline Terminal.
Figure 10-19 Raising the Base Plate on the DTU/DTP Multiline Terminal
Figure 10-20 Adjusting the Line Cord Length
Summary of Contents for ELECTRA ELITE IPK II
