___________________________________________________________________________________
13 - 36
Installing Cordless and Wireless Telephones
___________________________________________________________________________________
Document Revision 3
Electra Elite IPK II
10.1.1
Installing the Base Unit
1.
Connect the provided RJ-11 cable between the Base Unit and
the telephone jack.
2.
Connect the power cord to the Base Unit and plug it in an
electrical outlet.
3.
If desired, connect a recording device to the 2.5mm audio jack.
10.1.2
Connecting And Charging Batteries
1.
Slide the cover off the battery compartment on the bottom of
one pod.
2.
Connect the battery pack plug in the port in the compartment
and install the battery pack.
3.
Slide the cover back in place.
4.
Connect the power supply/charger to the conferencing pod and
plug it in an electrical outlet.
Charge batteries for 15 hours prior to first use.
5.
Repeat steps 1~4 for the other pod.
10.1.3
Keypad Functions
Refer to
Table 13-2 Keypad Functions
Key
Function
ON/OFF key
(telephone icon)
Press to activate the telephone and access dial tone.
Press again to hang up and return to standby mode.
PHONEBOOK (book
icon)
Press to dial stored numbers. Press and hold two
seconds to enter Phonebook Edit mode.
REDIAL (circular arrow
icon)
Press once to dial the last number called. Press and
hold two seconds to enter Program mode.
CONFERENCE (three
person icon)
Press to dial the conferencing service provider. This
feature must be programmed.
FLASH (lightning flash
icon)
Press to enable call forwarding, call waiting, or three-
way calling when supported by telephone service.
Summary of Contents for ELECTRA ELITE IPK II
