System Hardware Manual
4 - 1
___________________________________________________________________________________
___________________________________________________________________________________
Hardware Requirements
Chapter 4
S
ECTION
1
G
ENERAL
I
NFORMATION
The technician should be familiar with the Electra Elite IPK II system before trying to
install it. Review this chapter carefully.
S
ECTION
2
P
ROGRAMMING
S
TATIONS
Any multiline station can be a programming station in the Electra Elite IPK II system.
Station equipment connected to any port of an ESI(8)-U( ) ETU can be a
programming position, but requires a display multiline terminal.
S
ECTION
3
A
TTENDANT
S
TATIONS
Any display Multiline Terminal can be programmed as an Attendant position in the
Electra Elite IPK II system. An Attendant Position can have up to four DCR-60-1
Consoles attached. Each Attendant Console must be supported by an ESI(8)-U( )
ETU. A maximum of four Attendant Consoles can be installed in each Electra Elite
IPK II system.
S
ECTION
4
P
ROGRAMMING
FROM
A
PC
Electra Elite IPK II systems can be programmed using a personal computer. The
available Graphical User Interface allows the technician/end-user easy access to all
information that can be programmed on the Electra Elite IPK II system. The PC must
be a Pentium III 600 MHz or higher PC and have a Windows operating system
compatible with the PC Programming (PCPro) application.
Summary of Contents for ELECTRA ELITE IPK II
