2 - 450
Memory Blocks
___________________________________________________________________________________
Document Revison 1
Elite IPK
___________________________________________________________________________________
Notes
Page 7 – Trunks 49~56
LK 1
LK 2
LK 3
LK 4
LK 5
LK 6
LK 7
LK 8
49
50
51
52
53
54
55
56
Page 8 – Trunks 57~64
LK 1
LK 2
LK 3
LK 4
LK 5
LK 6
LK 7
LK 8
57
58
59
60
61
62
63
64
Programming Procedures
1
Go off-line.
2
Press LK4 to access the Memory Block.
3
Press the CO/PBX Line key to select Day ring assignment for Tel Port No.
The LED indication changes to indicate data each time a CO/PBX line key is pressed.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
K
~
I
to enter numeric data or Tel Port No.
– OR –
D
to go to next assigned Tel Port No.
C
to go to the next page
A
to go to the previous page
Default Values
CO/PBX lines 01 ~ 08 ring at Tel Port
numbers 01 and 02.
Tel Port numbers 03 ~ 120 do not ring
on any incoming CO/PBX calls.
4
Press
G
to write the data and display Memory Block 4-02.
5
After programming Memory Blocks 4-02~4-59, the next sequential Tel Port No. is automatically displayed.
6
Repeat steps 3, 4, and 5 until all Tel Port Nos. are programmed. Tel Port No. 01 is displayed again.
7
Press
E
to go back on-line.
Telephone ports A0~C0 are ports 100~120. Refer to Settings 1 to enter ports A0~C0.
CO/PBX
Line Key LED
Off
Green
Red
Data
No ring
Immediate
Ring
Delayed Ring
Summary of Contents for ElectraElite IPK
Page 2: ...PROGRAMMING MANUAL Stock Number 750825 Document Revision 1 Release 1000...
Page 3: ......
Page 5: ......
