Electra Elite IPK
Document Revison 1
Programming Manual
2 - 571
___________________________________________________________________________________
___________________________________________________________________________________
7-2
Telephone Type Assignment
General Description
Use this Memory Block to specify the device that is connected to an ESI port.
Display
Settings
Related Programming
Refer to individual features in the Electra Elite IPK Features and Specifications Manual.
Notes
LK 1
LK 2
LK 3
LK 4
LK 5
LK 6
LK 7
LK 8
The shaded
selection is the
default.
NON
TEL
CONSOL
SLT ADP
DIGITAL
VM
MSG
BOARD
Programming Procedures
1
Go off-line.
2
Press LK7 + LK2
to access the Memory Block.
3
To change data, press the corresponding CO/PBX line key.
Use the following to enter data:
D
to go to next assigned ESl Port No. or cycle back to 1.
4
Press
G
to write the data.
5
Press
E
to go back on-line.
1.
Only Multiline Terminals can be assigned to ports 01 and 02.
2.
A maximum of four Attendant Add-On Consoles can be installed in the system.
3.
A maximum of eight SLT(1)-U( ) ADP adapters can be installed in the system.
4.
A maximum of 16 Digital Voice Mail ports are available.
5.
When assigning SLT adapters or Digital Voice Mail ports, Memory Block 4-10 (Station Number Assignment) must
be reassigned also.
6.
The D
term
Cordless, D
term
Cordless II, D
term
Cordless Lite, or D
term
Cordless Handset Terminal uses TEL
selection.
7.
A maximum of eight basic Message Display Boards and 40 expansion boards are available.
ETU Mode
7
Telephone
2
Data No.
—
PC Programming
¦
+BS
0 1 : T E L
T I M E
D I S P L A Y
ESI
Port No.
(01~CO)
Setting
Data
Summary of Contents for ElectraElite IPK
Page 2: ...PROGRAMMING MANUAL Stock Number 750825 Document Revision 1 Release 1000...
Page 3: ......
Page 5: ......
