Elite IPK
Document Revision 1
Programming Manual
2 - 7
___________________________________________________________________________________
___________________________________________________________________________________
1-1-04
Automatic Redial Time Selection
General Description
When a called party is busy, the station user dials an Access Code and restores the
handset. Use this Memory Block to define the redial timing parameters when
automatic redial is set to a busy CO/PBX number. After the specified number of call
attempts with no answer, the system stops dialing.
Display
Notes
Programming Procedures
1
Go off-line.
2
Press LK1 +
LK1 +
KD
to access the Memory Block.
3
Use the dial pad to enter the Data Setting for Table 1.
Use the following to enter data:
J
to move the cursor left
L
to move the cursor right
Setting Data (Allowed):
Table 1 (Calling Time): 001~050 sec.
Table 2 (Call Waiting Time): 001~100 sec.
Table 3 (Call Attempts): 001~015 times
000 cannot be entered.
4
Press
G
to write the data and display the next table.
5
Repeat Steps 3 and 4 for each remaining table. After pressing
G
for Table 3, the next Memory Block is displayed.
6
Program the next Memory Block or press
E
to go back on-line.
1.
Definitions:
Calling Time: The time that the system automatically calls the busy CO/PBX number. After the programmed time
limit is reached, the call is abandoned.
Call Waiting Time: The time the system waits between call attempts.
Call Attempts: The number of times the system redials the busy CO/PBX number.
2.
When Call Pickup groups are assigned using Memory Block 4-09 (Telephone to Tenant Assignment), the CO
lines must be assigned to the same Tenant group in Memory Block 2-01 (Trunk to Tenant Assignment) for this
feature to work.
System Mode
1
Submode
1
Data No.
04
PC Programming
¦
+BM
0 4 : R E D I A L ( 1 )
0 3 0
T I M E
D I S P L A Y
Data
Setting
Title
Data
No.
Table
1~3
Default Values
Table
No.
Description
Value
1
Calling Time
030
2
Call Waiting Time
060
3
Call Attempts
002
Summary of Contents for ElectraElite IPK
Page 2: ...PROGRAMMING MANUAL Stock Number 750825 Document Revision 1 Release 1000...
Page 3: ......
Page 5: ......
