Electra Elite IPK
Document Revision 4
General Description Manual
2 - 37
___________________________________________________________________________________
___________________________________________________________________________________
P-3
POWER FAILURE TRANSFER
Power Failure Transfer ensures that a customer has access to the Central
Office network during a power outage. The CO/PBX tip and ring are
automatically transferred to the tip and ring of a preselected Single Line
Telephone. The Single Line Telephone can function in the system during
normal operation or be used during a power failure. Each B64-U( ) KSU
provides three circuits for this feature. When power returns, any
conversation in progress is disconnected.
P-4
PRESET DIALING
Preset Dialing enables a Multiline Terminal user to originate an outgoing call
by predialing digits on the keypad. After dialing the number, the user can go
off-hook, press the Speaker key, or press a line key to make the call.
P-5
PRIME LINE ASSIGNMENT
Prime Line Assignment allows a station user to go off-hook and originate an
outside call from the trunk assigned as the Prime Line without pressing the
line key. This feature allows assignment of a trunk, Trunk group, or Route
Advance Block.
P-6
PRIVACY ON ALL CALLS
The system provides complete Privacy on All Calls. A station user cannot
enter another conversation unless allowed using Barge-In, Add-On
Conference, or Privacy Release.
P-7
PRIVACY RELEASE
Privacy Release allows the multiline terminal user to release the privacy on
an outside line by pressing a privacy release key programmed on the station.
Another user can then press the same CO/PBX or CAP key to join the
conversation in progress.
P-8
PRIVATE LINES
Two outside lines can be programmed as private lines. Only a Multiline
Terminal that is programmed for the Private Lines feature can have access to
these private lines. The Private Line LED status is not displayed on any
other Multiline Terminal.
P-9
PROGRAMMING FROM MULTILINE TERMINAL
System Programming can be performed from designated Display Multiline
Terminals in the first two ESI(8)-U( ) ETU ports. Some programming changes
become effective immediately. Other programming changes become
effective after applicable busy telephones and circuits become idle.
Summary of Contents for ElectraElite IPK
