Compact Flash
28
XN120 EXIFU Guide
System Report
It is recommended that you also output the XN120 system report. This will show the cards installed in each slot
and the ports assigned.
You will need to connect the serial port of the EXIFU card to a COM port of your PC, refer to Testing the EXIFU
earlier in this guide for details.
Below is an example of a system report.
<< System Information >> 14/02/2004 04:34
slot location type assign port condition note
------------------------------------------------------------------------------
1 1-1 008/308 1- 8 Running **-**--- Connect:*
1- 3 Trunk port
2 1-2 008/308 9- 16 Running -------- Connect:*
4- 6 Trunk port
3 1-3 -none- -none- Not Install
4 1-4 -none- -none- Not Install
5 1-5 BRIU 17- 20 Running Station port
7- 14 Trunk port
6 1-6 -none- -none- Not Install
7 2-1 -none- -none- Not Install
8 2-2 -none- -none- Not Install
9 2-3 -none- -none- Not Install
10 2-4 -none- -none- Not Install
11 2-5 -none- -none- Not Install
12 2-6 -none- -none- Not Install
13 3-1 -none- -none- Not Install
14 3-2 -none- -none- Not Install
15 3-3 -none- -none- Not Install
16 3-4 -none- -none- Not Install
17 3-5 -none- -none- Not Install
18 3-6 -none- -none- Not Install
This report shows that the XN120 main unit has a 308 card and a 4BRIU card installed.
Slots 1-6 are in the Main unit
Slots 7-12 are in Expansion unit 1
Slots 13-18 are in Expansion unit 2