1. Turning on the Server
Express5800/T110j User’s Guide
104
Chapter 3 Setup
4. After a while, the following message is displayed on the screen.
Press <F2> to enter setup, <F3> Internal Flash Memory, <F10> Display Boot
Menu , <F12> Force Network Boot
You can call the functions below upon completion of POST by pressing the designated function key.
<F2> key: Run the SETUP. For information on the SETUP, see
Chapter 3 (2. System BIOS Setup)
.
<F3>
key:
Run EXPRESSBUILDER from Internal Flash Memory. For information on
EXPRESSBUILDER, see
.
Note
If bootable CD/DVD is inserted into optical disk drive, the system starts from
CD/DVD even if <F3> key is pressed.
<F10> key: Boot the boot menu.
<F12> key: Boot from network.
5. If you set a password at
SETUP
in the BIOS Setup utility, the password entry appears upon successful
completion of POST.
Up to three password entries will be accepted. Three incorrect password entries disable the server to
boot. In such a case, turn off the power and wait about ten seconds before turning on to boot the server.
Important Do not set a password before OS is installed.
6. The OS starts when POST is completed.
POST error messages
If POST detects an error, an error message is displayed on the screen or beeps are sounded. Write down
the error message for future use. For details, see "
Maintenance Guide
".
Summary of Contents for EXP339
Page 127: ...MEMO...