2. List of Windows Event Logs
Express5800/E120g-M Maintenance Guide
181
Chapter 3 Appendix
4
l2nd
Warning
QLogic BCM57810 #xx: The network link is down.
Check to make sure the network cable is properly connected.
When installing an OS, starting system,
or applying Starter Pack
This event does not affect system operation.
11
Megasas
Error
The driver detected a controller error on
\Device\RaidPort(x)
.
When applying Starter Pack
This event does not affect system operation if it is logged when applying
Starter Pack.
24
mlx4_bus
Warning
MLX4_SF_32_0_0:
Problem - The port was configured to use auto sensing for deciding the
port type. Port * failed to dete ct the port type automatically.
Impact - As a result the port is being started as an IB port (unless the
port is ETH only). This may cause a connection problem if the other side
is an ETH port.
Reason and suggestion to fix - This problem may happen since the
computer is connected back to back or the cable is unplugged.
To solve this issue connect the port to a switch or define the port type.
explicitly (IB or ETH) instead of auto.
* There may be cases that the above message is somewhat different.
At the time of system start-up
This event is logged in the system when InfiniBand Adapter is
connected.
This event will be recorded when the type of port could not be
recognized automatically such as InfiniBand cable is not connected.
27
e1iexpress
Warning
Intel(R) I350 Gigabit Network Connection #xx
Network link is disconnected.
When installing an OS
This event does not affect system operation.
27
e1rexpress
Warning
Intel(R) I350 Gigabit Network Connection #xx
Network link is disconnected.
When starting system,
or applying Starter Pack
This event does not affect system operation.
27
ixgbi
Warning
Intel(R) Ethernet Controller X540-AT2 #xx
Network link is disconnected.
When installing an OS
This event does not affect system operation.
27
ixgbt
Warning
Intel(R) Ethernet Controller X540-AT2 #xx
Network link is disconnected.
When starting system and installing
Starter Pack
This event does not affect system operation.
46
volmgr
Error
Crash dump was not initialized.
When installing an OS
Refer to the following website.
http://support.microsoft.com/kb/2756313
129
Megasr1
Warning
Reset was issued to the device \Device\RaidPort0.
During consistency check
If this message has been registered as a log, there is no problem since
the OS has succeeded in retry. Continue using.
