2. Server Configuration
Express5800/R120g-1M, R120g-2M Maintenance Guide
109
Chapter 2 Useful Features
(2/2)
Item Description
Default
Value
IPv6 Property
IPv6
Enable or disable IPv6.
Disable
Address Assignment
Mode
Specify the mode to assign IPv6 address (Static or Dynamic).
*12
Dynamic
Link Local Address
Display link local address.
*12
–
Global Address
Display IPv6 address when Dynamic is specified for assignment mode.
*12
*13
–
Static Address
Specify IPv6 address when Static is specified for assignment mode.
*12
0::0
Prefix Length
Specify the prefix length when Static is specified for assignment mode.
*12
64
Gateway Address
Specify the gateway address when Static is specified for assignment mode.
*12
0::0
Access Limitation
Limitation Type
Select the Access Limitation Type.
Allow All
: Access to BMC is not limited.
Allow Address
: Specify the IP Address that is allowed to access BMC.
Deny Address
: Specify the IP Address that deny to access BMC.
Allow All
IP Address
Specify the IP Address (IPv4) to allow or deny to access with BMC.
*8
*9
Blank
Service
HTTPS
Enable or disable HTTPS service.
*10
Enable
HTTPS Port Number
Specify the HTTPS port number.
*11
443
HTTP
Enable or disable HTTP service.
*10
Enable
HTTP Port Number
Specify the HTTP port number.
*11
80
SSH
Enable or disable SSH service.
Enable
SSH Port Number
Specify the SSH port number.
*11
22
*1: Can be specified if the server supports this feature.
*2: When set to "Shared BMC LAN", the BMC LAN port is disabled. When set to "Shared BMC LAN", the system (OS) LAN port
also transmits or receives data. Thus, the network performance may be reduced due to load of system LAN (or BMC LAN).
When set to "Shared BMC LAN", it is disconnected for some seconds as system LAN is linked down for some seconds when
system is turned off, turned on, reset, or when the LAN driver is loaded or unloaded.
*3: If an illegal value is specified for subnet mask, an error message is displayed and setting is disabled.
*4: Can be changed only when DHCP is set to "Disable".
*5: Can be changed only when DHCP is set to "Enable".
*6: Host Name should be within 63 characters.
Acceptable characters are: alphanumeric, hyphen (-), underscore (_), and period (.).
*7: Host Name and Domain Name should be within total of 255 characters.
Acceptable characters are: alphanumeric, hyphen (-), underscore (_), and period (.).
*8: The range of IP address to "Allow" or "Deny" access is delimited by ",(Comma)". With regard to the setting of “Deny” access,
"*(Asterisk)" can be described as a wild-card. (ex: 192.168.1.*,192.168.2.1,192.168.2.254)
*9: Can be specified when Access Limitation Type is "Allowed Address" or "Deny Address". The length must not exceed 255
characters.
*10: If HTTP is set to "Enable", HTTPS is changed to "Enable" automatically. You are not allowed to set "Enable" to HTTP only.
*11: Port number can be specified only when the relevant port is set to "Enable". The port number must be unique.
*12: Can be specified only when IPv6 is set to "Enable".
*13: Displayed only when "Dynamic" is specified for Address Assignment Mode.
