2. Description on System Utility
Express5800/R120h-2M (2nd-Gen) User’s Guide
229
Chapter 3 Setup
2.
Description on System Utility
Here we describe System Utility. You need to fully understand the content and configure correctly.
2.1
Overview
System Utility is a utility to set up this device. This utility is installed in a flash memory in the server as standard
and can be run without requiring a media for boot.
Since the device is delivered with optimum set-up, in almost all cases no change is required.
Use only when
the case applies to any of cases described in
Chapter 3 (2.4 Cases that Require Configuration)
.
By using System Utility, wide variety of set-ups as follows become possible.
Configuration of the system device and options installed.
Enabling and disabling system functions
Display of system information
Selection of Primary Boot Controller
Configuration of Memory Option
Selection of language
Start of pre-boot environment such as built-in UEFI shell or EXPRESSBUILDER.
Regarding the details of System Utility, see
Chapter 1 (1. System Utility)
of
Maintenance Guide (Common).
Important
Back up the system information beforehand to provide against an
unexpected failure or an update of System ROM.
After changing the settings of System Utilities, make sure to create a backup.
For details on how to create a backup, refer to
"1.
System Utilities"
in
Chapter 1
of
"Maintenance Guide (Common)"
.
2.2
Starting SETUP Utility
Run POST following
Chapter 3 (1.1.1 POST sequence)
.
After a while, the following message is displayed on the screen. (The on-screen message depends on your
environment.)
By pressing <F9> Key here, System Utility starts after POST is completed.
Furthermore, if an Admin Password has been set, a dialog box for password input will be displayed before
starting the system utility. Please enter the correct Admin Password.
