TM700 User Guide - Problem Solving
5 - 5
Problems at initial System Start-up
Problems that occur at initial system start-up are often caused by incorrect installation
of components or incorrect configuration. Hardware failure is a less frequent cause.
■
Are all cables properly connected and secure?
■
Is AC power available at the wall outlet?
■
Are the configuration settings correct in Setup?Are all drivers properly installed?
■
Are all the expansion cards fully seated in their slots on the motherboard?
■
Are all DIMMs installed correctly?
■
Is the processor fully seated in its slot on the motherboard?
■
Are switches and jumpers on the system board correct (if they have been changed
from their original default settings)?
■
Are all jumper and switch settings on optional add-on cards and peripheral devices
set correctly? Check the documentation included with these devices for details.
Ensure that there are no system resource conflicts between hardware components.
(For example, two add-on cards could inadvertently share the same interrupt,
resulting in a conflict.)
■
Are adapter cards and disk drives correctly installed?
■
Is the keyboard properly connected to the system and is it connected in the right
PS/2 port?
■
Is a bootable diskette installed in your system's floppy drive A: ?
■
Is the hard disk properly formatted or defined?
■
Is the operating system properly loaded? Check the operating system documenta-
tion.
Summary of Contents for Express 5800 TM700
