TM700 User Guide - Setting Up the System
2 - 9
CAUTION
Always allow POST to complete before powering down your
system.
If you have problems powering on your system, refer to
Problem Solving
in Chapter 5
of this User’s Guide.
After you have successfully powered on your system, insert the EXPRESSBUILDER
CD-ROM into the CD-ROM device, reboot the system and follow the screen prompts
to run EXPRESSBUILDER.
Powering Off the Server System
When server system power is on, pressing the power on/off switch on the front panel of
the server turns the power off.
To turn the server system power off:
1.
Shutdown the operating system (OS).
2.
If necessary, press the POWER switch on the front of the computer chassis again
to power off the system. The POWER lamp lights off.
3.
Power off the peripheral devices.
Note:
If the server power cord is connected to a power
control unit such as an UPS (Uninterruptible Power Supply),
refer to the UPS user's guide for proper power-off procedures.
Forcing a Power Shutdown
A forced power shutdown can be used when the power on/off switch does not power
off the server or the reset functions do not work.
To perform a forced power shutdown:
■
Press in on the power on/off switch located on the front panel of the server for at
least 4 seconds to force the server power off.
To power on after a forced shutdown, wait 10 seconds and then power on again.
!
Summary of Contents for Express 5800 TM700
