Setting Up Your Modular Server 3-13
4.
Hold the lock lever and pull the modular server out from the Module Enclosure. Pull out
approximately 10 cm so that you can hold the top and bottom of the frame of the modular
server.
IMPORTANT:
Do not hold the lock lever. Doing so may cause the
Modular Server to fall down or be damaged due to deformed lock lever.
5.
Hold the top and bottom of the frame of the modular server, and take the Modular Server
out from the Module Enclosure.
6.
Put the modular server on the clean, rigid and flat desk. Tighten the thumbscrew to lock
the modular server.
Lock lever
Lock lever
Summary of Contents for EXPRESS5800/100 SERIES N8100-1635F
