Upgrading Your Server 9-9
HARD DISK DRIVE
Your system supports the serial attached SCSI (SAS) hard disk drives.
IMPORTANT:
Do not use any hard disk drives that are not authorized
by NEC. Installing a third-party hard disk drive may cause a failure of
the server as well as the hard disk drive. Purchase hard disk drives of
the following models:
– N8150-199 (36.3 GB, 15,000 rpm, SAS)
– N8150-200 (73.2 GB, 15,000 rpm, SAS)
– N8150-201 (146 GB, 15,000 rpm, SAS)
– N8150-226 (300 GB, 15,000 rpm, SAS)
SAS Port
The hard disk drive bay may contain up to six hard disk drives. The SAS port numbers are
factory-assigned to hard disk drives as shown below.
0
1
2
3
4
5
SAS Port 0
SAS Port 1
SAS Port 5
SAS Port 4
SAS Port 3
SAS Port 2
The hard disk drive bays are connected to the SAS connector on the mother board when the server
is shipped.
A dummy block is installed in the hard disk drive bays except the one with SAS Port 0 defined. The
purpose of a dummy block is to increase the cooling effect in the server. Install a dummy block in
slots not containing a hard disk drive.
Summary of Contents for Express5800/120Ri-2
