Upgrading Your Server 9-47
7.
<This step is required only for a PCI board of the full-height/full-length type.>
Before installing a PCI board of the full-height/full-length type, remove the retainer from
the PCI board, and then unlock and open the card retainer clip on the other side of the
guide rail.
Retainer
8.
Install the PCI board on the riser card.
Align the PCI board terminal section with the riser card slot, and firmly push the PCI
board until it is fully seated.
Guide
rails
Top end of the
PCI board bracket
Low-profile type
Full-height type
IMPORTANT:
Do not touch the terminals of the riser cards and PCI boards with
your bare hand. Fingerprints and dust left on them cause the server
to malfunction.
If you are unable to install a PCI board correctly, remove it, and
then install it again. Be careful not to apply excess force to a PCI
board or riser card. Doing so may damage the card.
Summary of Contents for Express5800/120Ri-2
