2-32 General Description
After taking out the disc, return the tray into the drive.
When you fail to eject the tray with the Eject button and take out the disc from the server, follow the
procedure below.
Emergency hole
1.
Press the POWER switch to power off the server. (The POWER LED goes off.)
2.
Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a
straightened large paper clip will make a substitute) into the emergency hole on the right
front of the DVD-ROM drive and gently push it in until the tray is ejected.
IMPORTANT:
Do not use a toothpick or plastic stick that is easy to break.
If the above procedure does not let you take out the disc, contact
your service representative.
3.
Hold the tray and pull it out.
4.
Take out the disc.
5.
Push the tray back into position.
Summary of Contents for Express5800/120Ri-2
