2-36 General Description
When you fail to eject the CD/DVD-ROM tray with the CD/DVD-ROM tray eject button and take
out the CD/DVD-ROM from the server, follow the procedure below.
1.
Press the POWER switch to power off the server. (The POWER/SLEEP lamp goes off.)
2.
Insert a metal pin of approximately 1.2 mm in diameter and 100 mm in length (a
straightened large paper clip will make a substitute) into the emergency hole on the upper
front of the DVD-ROM drive and gently push it in until the tray is ejected.
IMPORTANT:
Do not use a toothpick or plastic stick that is easy to break.
If the above procedure does not let you take out the CD/DVD-ROM,
contact your service representative.
3.
Hold the tray and pull it out.
4.
Take out the CD/DVD-ROM.
5.
Push the tray back into position.
Summary of Contents for Express5800/140Re-4
