Upgrading Your Server 9-15
Top Cover
To install or remove the PCI board, or to change cable connections of internal cable, you will need
to remove the top cover.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
Be sure to power off the server before removing the top cover.
Removal
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
2.
Remove the front bezel.
3.
Pull out the server from the rack.
4.
Loosen the two captive screws on the front panel.
5.
Slide the top cover toward the rear of the chassis.
6.
Lift the cover up and off of the chassis.
Captive screws
Summary of Contents for Express5800/140Rf-4
