4-42 System Configuration
See the following table for each item.
Item Parameter
Description
Format Disk
―
Low-level format is simulated by writing entire disk to
zero.
TIPS:
Low-level format is performed to the disk drive at
factory.
You do not need to perform low-level format again.
IMPORTANT:
All the data on the disk is deleted. Back up your data
before performing this operation.
Verify Disk Media
―
Check for errors by scanning the disk drive media
Indicate LED
―
Flash the LED on the selected disk drive.
Write Cache
Setting
Enabled
[Disabled]
Enable/Disable Write Cache.
Connection Rate
[Auto]
1.5Gb/s
3.0Gb/s
The data transfer rate of disk drive. The initial value is
set to [Auto]. You do not need to change it.
Set Bootable
Enabled
[Disabled]
Set the disk drive to the bootable disk drive. You do
not need to change it.
[ ]: factory default
Adaptec SAS/SATA Controller#0
Device Box Slot Model FW Rev
#0 FF FF HITACHI HUS151436VLS300 A340
#1 00 FF No device
#2 00 FF No device
#3 00 FF No device
#4 00 FF No device
#5 00 FF No device
#6 00 FF No device
#7 00 FF No device
#8 00 FF No device
#9 00 FF No device
#10 00 FF No device
#11 00 FF No device
#12 00 FF No device
#13 00 FF No device
#14 00 FF No device
#15 00 FF No device
Select SAS/SATA Disk and press <Enter>
Drive with + sign is Bootable
Use Page Up or Page Down keys to move to next page
Format Disk
Verify Disk Media
Indicate LED
Write Cache Setting
Connection Rate
Set Bootable
Summary of Contents for Express5800/320Fd-MR
