3-26
ESMPRO Agent for Linux
Warning Message about CPU Load
When NEC ESMPRO Agent detects that it cannot get performance information
from the OS because of temporarily insufficient system resources or a high load
rate, NEC ESMPRO Agent registers the following syslog message
Source:
ESMCpuPerf
Type:
Information
Event ID: 9005
Explanation: System performance information cannot be obtained.
(Code=xxxx)
If NEC ESMPRO Agent cannot get performance information, it processes the
load rate as 0%. If events, which do not permit NEC ESMPRO Agent to get
information occur consecutively, the displayed CPU load rate may be lower than
the actual value.
Stopping of the Primary PCI Module by the Server Utility
When the server utility is used to stop the primary PCI module, the server utility
screen may be difficult to view. However, in this case, there are no functional
problems.
Collection of Dump by the Server Utility
When the dump function is executed by the ft server utility, messages for the
dump to be output by the driver are written over the display on the server utility
screen. As a result, the server utility screen may be difficult to view, however
there are no functional problems.
