ftSMC Component Actions
ftSMC Component Properties and Actions
3-25
Initiate BringUp
Powers the component on and brings it into service (online). The component
must be offline, broken, or shot.
Initiate Diagnostics
Runs diagnostic tests on the component. The component must be out of
service (offline) before you can run diagnostics. Initiate Diagnostics turns on
power to the component to run the diagnostic tests. This action is unavailable
if the component is online. Diagnostics also run just prior to bringing the
device into service.
Initiate Jump Switch
Switches from one or more running CPUs to a new CPU and displays the
status of the operation. Normally used to upgrade the CPU element BIOS.
Issue Bus Reset
Resets the bus. Normally, when a bus error occurs, the bus resets
automatically. Typically, the NEC Technical Support initiates this action only
when the bus does not reset after a bus error.
Join ftGateway
Group
Adds a slave system to an existing ftGateway group.
Launch Intel
PROSet
Launches the Intel
®
PROSet utility.
Leave ftGateway
Group
Removes a slave system from an ftGateway group.
Perform Memory
Check
Performs a memory comparison on all online CPU elements. A memory
check involves a read, followed by a write if an error is detected, of every
location in memory. This is necessary to ensure that memory on all CPU
elements is identical in content. When elements are initially partnered,
memory is automatically checked. A dialog box indicates the status of the
action; click OK to close the dialog box.
Remove ftGateway
Group
Removes an ftGateway group. You must remove all slave systems from the
group prior to executing this action.
Remove Physical
Disk from RDR
Virtual Disk
Deletes all of the data from the RDR target disk.
Renew DHCP
Renews the dynamic host configuration protocol (DHCP) IP addresses used
for the VTM Internet connection.
Reset Device
Properties
Resets configurable device properties to the default values and displays the
status of the operation.
Reset Driver
Properties
Resets all Board Instance Driver - srabid configurable properties to their
default values.
Table 3-2. ftSMC System Inventory Component Actions (Continued)
Action
Description
Summary of Contents for Express5800/320Ma
Page 1: ...NEC Solutions America Inc NR550 Express5800 320Ma Technical Reference Guide...
Page 10: ...Preface x Express5800 320Ma Technical Reference Guide...
Page 24: ...ASN Connection Retry Cycle 2 10 Express5800 320Ma Technical Reference Guide...
Page 52: ...ftSMC Component Actions 3 28 Express5800 320Ma Technical Reference Guide...
