1. Installing Internal Optional Devices
Express5800/E120d-1 User’s Guide
50
Chapter 2 Preparations
1.6
Processor(CPU)
You can configure the multi-processor system by adding an optional processor.
Important
You must avoid static electricity to work with the procedure below. For details,
refer to Chapter 2 (1.2 Anti-static Measures).
Make sure to use the processor authorized by NEC. Installing a third-party
processor may cause a failure of the processor as well as the motherboard.
Repair of the server due to failures or damage resulted from installing such a
processor will be charged.
Please check available CPU so that CPU of a different frequency isn't
intermingled.
When adding CPU, please change the installing point of a installed memory. For
details, refer to Chapter 2 (1.7 DIMM).
1.6.1
Installation
Follow steps below to install the processor.
1.
Refer to steps 1 to 6 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Remove the DUCT which cover CPU.
3.
Check the position of a CPU socket where a processor is installed.
4.
Push down the socket lever once to unlatch it from the hook, then slowly open the lever until it stops.
CPU #2
CPU #1
