2. BIOS Setup Utility (SETUP)
Express5800/E120d-1 User’s Guide
98
Chapter 3 Setup
2.
BIOS Setup Utility (SETUP)
This section describes how to configure Basic Input Output System (BIOS).
Before you install the server and add or remove optional devices, make sure you have read and understood
this section to configure properly.
2.1
Overview
BIOS Setup Utility (SETUP) is a utility to do basic hardware settings. This utility is installed in a flash memory
in the server as standard and can be run without requiring a media for boot.
BIOS settings were configured with optimal settings before the server was shipped to you. Therefore, in most
of cases, you should not need to use the SETUP.
Use only when the case applies to any of cases
described in Chapter 3 (2.4 Cases that Require Configuration)
.
2.2
Starting and Exiting SETUP Utility
2.2.1
Starting SETUP
Run POST following
Chapter 3 (1.1.1 POST sequence)
.
After a while, the following message will be displayed on the lower left of the screen.
Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network
If you press <F2> key at this time, SETUP runs and displays
Main
menu upon completion of POST. (You can
also press <F2> key while NEC logo appears to display
Main
menu.)
Tips
If password is set, you will be prompted to enter password at next startup of
SETUP. (The timing when prompt appears depends on setting of password.)
Up to three password entries are accepted. If you enter incorrect password
consecutively three times, the system halts (you can no longer proceed).
In this case, power off the server once, then power it on.
2.2.2
Exiting SETUP
To exit SETUP after saving parameters, select
Save & Exit
Save Changes and Exit
.
To exit SETUP without saving parameters, select
Save & Exit
Discard Changes and Exit
.
Tips
To restore the default value, select
Save & Exit
Load Setup Defaults
.
(The default value might be different from the factory setting.)
