5. RAID System Configuration
Express5800/R110i-1, T110i-S, T110i Maintenance Guide
146
Chapter 2 Useful Features
4.
Create a virtual drive. The procedure for creating a new virtual drive is different from that for adding a
virtual drive. Creating a new virtual drive is to create a virtual drive by using a new physical device.
Adding a virtual drive is to create an additional virtual drive by using an unused area of the existing
Drive Group.
The procedures to create the virtual drive in each case are following below.
Note
Up to eight virtual drives can be created.
For RAID10, only creating a new virtual drive is available.
For RAID10, the virtual drive is configured with the maximum capacity. You
cannot specify the capacity.
4-1. New creation (RAID0/1)
1)
On the screen shown in step 3, select “Unconfigured Capacity” of
Select Drives From
.
2) Select
Select Drives
, and then select the device type for
Select Media Type
.
Note
Do not select
Both
. This platform does not support
Both
of Media Type.
The options for
Select Media Type
vary depending on the connected device.
