1. POST Error Message
Express5800/R110i-1, T110i-S, T110i Maintenance Guide
195
Chapter 3 Appendix
(2) Beep
code
If POST detects a problem and is unable to display the error message, the beep code sounds instead of
displaying the message.
A beep code is a series of short beeps separated by pauses. For example, "1-3-3-1" indicates one beep, a
pause, three beeps, a pause, three beeps, a pause, and one beep.
The table below shows the beep code, cause, and action.
If the same error appears even if the action is performed, contact your sales representative.
Beep Code
Description
Action
1-3-3-1
No memory in the server.
Make sure that the DIMMs are correctly
installed. If the DIMM is installed correctly,
contact your sales representative.
1-5-2-1
No processor in the server.
Make sure that the processor is correctly
installed. If the processor is installed correctly,
contact your sales representative.
1
An error occurred during the POST
processing.
Contact your sales representative.
4
Initializing the BIOS executable module
failed.
Contact your sales representative.
5
No graphics controller in the server.
Contact your sales representative.
7
Resetting the system failed.
Contact your sales representative.
8
An error was detected during allocating the
PCI resources.
Remove all the PCI boards from the PCI slots,
and then restart the server.
