5. Troubleshooting
Express5800/R110i-1, T110i-S, T110i Maintenance Guide
32
Chapter 1 Maintenance
To change disk format, first erase the disk contents of installation destination, and create the partition
again. Before creating a new partition, be sure to backup the necessary data.
Did you configure the RAID controller?
For the RAID array, use EXPRESSBUILDER or a RAID Configuration Utility (LSI Software RAID
Configuration Utility, Off-line Utility) to properly configure the RAID controller before installing OS.
Did you create a logical drive?
For the RAID array, create a logical drive using EXPRESSBUILDER, LSI Software RAID Configuration
Utility, Off-line Utility to install OS.
[?]
Unable to install Windows
Have you checked precautions for installation?
For installing OS, see "
Installation Guide (Windows)
".
[?]
The following devices are indicated as faulty devices in a server core installation of Windows
SM Bus Controller
PCI Simple Communications Controller
Base System Device
System Interrupt Controller
Performance
Counters
PCI
Device
PCI Data Acquisition and Signal Processing Controller
PCI Memory Controller
Not
Available
Universal Serial Bus Controller (only Windows Server 2008 R2)
There is no operational problem.
[?]
The following message appears when installing the OS, and you cannot proceed
Windows Server 2008 R2 cannot be installed from USB interfaced optical disk drive. Install from built-in
optical disk drive.
[?]
Unable to access the partition which was previously created after reinstalling while several disks are
connected
For details, refer to the website below.
http://support.microsoft.com/kb/2497048/ja
(Japanese text only)
[?]
When Windows Server 2008 R2 is installed while several disks are connected, the system partition and
the boot partition (100 MB) are created in another disk
For details, refer to the website below.
http://support.microsoft.com/kb/2530901/ja
(Japanese text only)
