7. Resetting and Clearing the Server
Express5800/R110i-1, T110i-S, T110i Maintenance Guide
48
Chapter 1 Maintenance
The following instructions show how to clear the CMOS memory and the password.
WARNING
Be sure to observe the following precautions to use the server safety. Failure to
observe the precautions may cause death or serious injury. For details, see
Safety Precautions and Regulatory Notices
.
Do not disassemble, repair, or alter the server.
Do not remove lithium, NiMH, or Li-ion batteries.
Disconnect the power plug before installing or removing the server.
CAUTION
Be sure to observe the following precautions to use the server safely. Failure to
observe the precautions may cause burns, injury, and property damage. For
details, see
Safety Precautions and Regulatory Notices.
Make sure to complete installation.
Do not get your fingers caught.
Avoid installing under extreme temperature conditions.
Important Take anti-static measures before operating the server. For details, see
Safety
Precautions and Regulatory Notices
(
1.8 Anti-static Measures)
.
Clearing NVRAM memory
1. See "
Getting Started
" provided with this server or
Chapter 2 (1. Installing Internal Optional Devices)
in
"
User’s Guide
"
to remove Top Cover.
2. Locate Clear NVRAM Jumper (J_CLRCMOS) by referring the above figure.
3. Change the jumper switch from
Keep
to
Clear
.
4. Wait at least five seconds and then return the jumper to
Keep
.
5. Reassemble the server, and then turn on the server.
POST will halt with the following error massage.
ERROR
8006: System configuration data cleared by Jumper.
Press <F1> to resume, <F2> to Setup
6. Press <F2> key to start BIOS Setup Utility, and then run
Load Setup Defaults
from
Save & Exit
menu.
The server will restart once before the OS starts.
Tips
After this operation, system may restart once before the OS is started.
