2. Server Configuration
Express5800/R120g-2E, T120g Maintenance Guide
118
Chapter 2 Useful Features
(2/2)
Item Description
Default
Value
Alert Level
Alert Level
Specify the kind of event to alert.
Error, Warning
Error
: When "Error" is detected in each sensor type, the alert is sent to the
selected address among To1 to To3.
Error, Warning
: When "Error" or "Warning" is detected in each sensor type, the alert is sent
to the selected address among To1 to To3.
Error, Warning, Information
: When "Error", "Warning" or "Information" is detected in each sensor type,
the alert is sent to the selected address among To1 to To3.
Separate Setting
: You can arbitrarily select the event and the address (To:X) to alert in each
sensor type.
Alert Test
Execute test by sending an alert by mail.
*10
–
*1: When Mail Alert is enabled, at least one address should be enabled.
*2: Can be specified only when To:X is set to "Enable".
*3: Up to 255 characters including alphanumeric, hyphen, underscore, period, and @ (at mark) can be used.
*4: Up to 63 alphanumeric characters exc, ", ?, =, <, >, #, and ¥ can be used.
*5: Up to 255 alphanumeric characters, hyphen, and period can be used for full domain name or IP address.
*6: Can be specified only when SMTP Authentication is set to "Enable".
*7: When SMTP Authentication is set to "Enable", at least one of the authentic methods should be enabled.
*8: Up to 64 alphanumeric characters can be used excluding " " blank, ",?, =, <, >, #, and ¥.
*9: Up to 19 alphanumeric characters can be used excluding " " blank, ",?, =, <, >, #, and ¥.
*10: Be sure to perform Alert Test after all the parameters are configured appropriately. Alert feature may fail depending on
configuration made for network or alert receiver.
Summary of Contents for Express5800/R120g
Page 231: ...MEMO...
