1. Installing Internal Optional Devices
Express5800/R120h-2M User’s Guide
101
Chapter 2 Preparations
1.14
RAID controller (PCI Board Type-p)
RAID controller (PCI Board) is supported.
RAID controller N8103-195/196/201 are provided.
Important The surface becomes hot after use so to avoid burns please allow the drive
and internal parts of the system to cool before touching.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Installing RAID Controller
Please prepare the following before installing the option.
Parts included in the option kit
To install the components, follow these steps.
1.
Make sure that the following requirements are met.
The RAID controller battery must be installed in a controller with the FBWC function (N8103-196/201).
If connecting a cable, make sure to connect to a component connector according to the label attached
on the cable.
Confirm that the RAID controller and SAS Expander firmware are updated to the latest versions.
2.
See steps 1 to 7 in
Chapter 2 (1.2 Overview of Installation and Removal)
for preparations.
3.
Raise two screw handles at the top of riser card (Butterfly Riser) and turn them to the left 180 degrees.
Then hold both sides of cage and lift them upright to remove the cage.
