2. BIOS Setup Utility (SETUP)
Express5800/R310g-E4, R320g-E4, R320g-M4 User's Guide
68
Chapter 3 Setup
2.
BIOS Setup Utility (SETUP)
This section describes how to configure basic input/output system (BIOS). Make sure that you understand the
descriptions in this chapter to configure BIOS properly.
2.1
Overview
BIOS Setup Utility (SETUP) is a utility to set basic hardware settings. This utility is installed in a flash memory
on the server as standard.
Factory settings of BIOS are set with optimal values. Usually, you do not need to run SETUP.
Modify the
settings only at the cases described in
Chapter 3 (2.4 Cases that Require Changes
.
2.2
Starting and Exiting SETUP
2.2.1
Starting SETUP
Run POST following
Chapter 3 (1.1.1 POST process)
.
After a while, the following message will be displayed on the lower left of the screen. The on-screen message
depends on your system environment.
Press <F2> SETUP, <F4> ROM Utility, <F12> Network
If you press <F2> key, SETUP starts upon completion of POST, and the
Main
menu appears .
If you have set a password, the following message appears and prompts you to enter the password.
Enter Password [ ]
If you enter incorrect password consecutively three times, the operation stops and you cannot proceed. No more
operations can be done. Turn off the power.
2.2.2
Exiting SETUP
To exit SETUP after saving changes, choose
Save & Exit
Save Changes and Exit
.
To exit SETUP without saving changes, choose
Save & Exit
Discard Changes and Exit
.
Tips
To restore the default value, choose
Save & Exit
Load Setup Defaults
.
Some values are different from the factory settings.
Values
of
ISCSI Configuration
submenu of
Advanced
menu and
UEFI Driver
Configuration
submenu do not return to default values.
Summary of Contents for Express5800/R310g-E4
Page 83: ...MEMO...
