2. BIOS Setup Utility (SETUP)
Express5800/T110h-S User’s Guide
95
Chapter 3 Setup
2.
BIOS Setup Utility (SETUP)
This section describes how to configure Basic Input Output System (BIOS).
2.1
Overview
BIOS Setup Utility (SETUP) is a utility to configure basic hardware settings. This utility is installed in the server
as standard.
Factory settings of BIOS are set with optimal values. Usually, you do not need to run SETUP.
Modify the
settings only at the cases described in
Chapter 3 (2.4 Cases that Require Changes
.
2.2
Starting and Exiting SETUP
Starting SETUP
2.2.1
Run POST following
Chapter 3 (1.1.1 POST sequence)
.
After a while, the following message will be displayed on the lower left of the screen. (The on-screen
message varies depending on the environment.)
Press <F2> SETUP, <F4> ROM Utility, <F12> Network
If you press <F2> key, SETUP starts upon completion of POST, and the
Main
menu appears .
Tips
In Legacy boot mode, you can also launch SETUP by pressing the <F2> key while
expanding option ROM.
If you have set a password, the following message appears and prompts you to enter the password.
Enter Password [ ]
If you enter incorrect password consecutively three times, the operation stops and you cannot proceed. Turn
off the power, and try again.
Exiting SETUP
2.2.2
To exit SETUP after saving changes, choose
Save & Exit
→
Save Changes and Exit
.
To exit SETUP without saving changes, choose
Save & Exit
→
Discard Changes and Exit
.
Tips
•
If you wish to restore the setting to default values, select
Save & Exit
and then
Load
Setup Defaults
. (The default value might be different from the factory setting.)
•
You cannot restore the default value in the following submenus in
Advanced
menu:
–
iSCSI Configuration
submenu
–
UEFI Driver Configuration
submenu
