1. POST Error Message
Express5800/T120e Maintenance Guide
120
Chapter 3 Appendix
(2/7)
Error Message
Cause
Solution
9041
Detected CPU Error on CPU #1
An error was detected on CPU
#1.
9042
Detected CPU Error on CPU #2
An error was detected on CPU
#2.
9060 PEI_CPU_MISMATCH
CPU #1 and #2 are not the
same type.
9080
Link in Slow Speed Mode
between CPU1 and CPU2.
Low-speed mode was detected
on bus between CPU1 and
CPU2.
9081
Link Failure between CPU1 and
CPU2.
Link failure was detected
between CPU1 and CPU2.
9082
Link Width Error between CPU1
and CPU2.
Link width Error between CPU1
and CPU2 was detected.
9E80
Forced to use CPU with error.
An error was detected in CPU,
but the CPU was forcedly
enabled.
A001
Memory Error detected in
CPU1_DIMM1
An error was detected in
CPU1_DIMM1.
A002
Memory Error detected in
CPU1_DIMM2
An error was detected in
CPU1_DIMM2.
A003
Memory Error detected in
CPU1_DIMM3
An error was detected in
CPU1_DIMM3.
A004
Memory Error detected in
CPU1_DIMM4
An error was detected in
CPU1_DIMM4.
A005
Memory Error detected in
CPU1_DIMM5
An error was detected in
CPU1_DIMM5.
A006
Memory Error detected in
CPU1_DIMM6
An error was detected in
CPU1_DIMM6.
A007
Memory Error detected in
CPU2_DIMM1
An error was detected in
CPU2_DIMM1.
A008
Memory Error detected in
CPU2_DIMM2
An error was detected in
CPU2_DIMM2.
A009
Memory Error detected in
CPU2_DIMM3
An error was detected in
CPU2_DIMM3.
A00A
Memory Error detected in
CPU2_DIMM4
An error was detected in
CPU2_DIMM4.
A00B
Memory Error detected in
CPU2_DIMM5
An error was detected in
CPU2_DIMM5.
A00C
Memory Error detected in
CPU2_DIMM6
An error was detected in
CPU2_DIMM6.
Contact your sales representative.
A420
Online Spare Memory was not
ready.
Memory Sparing feature cannot
be used in this DIMM
configuration.
A421
Mirroring Memory was not
ready.
Memory Mirroring feature
cannot be used in this DIMM
configuration.
A423
Lockstep was not ready.
Memory LockStep feature
cannot be used in this DIMM
configuration.
Launch the SETUP utility and check the setting of
Memory RAS Mode
. This POST error occurs if
memory sparing, memory mirroring, or memory
lock step is enabled or the DIMM is degraded. To
solve this problem, launch the SETUP utility,
change the
Memory Retest
setting to "Yes", and
then execute
Save Changes and Exit
.
If this does not solve the problem, contact your
sales representative.
A800
Memory not detected
No valid memory is not
installed.
Check if DIMMs are properly installed. If the
same error is detected repeatedly, contact
your sales representative.
A804
Latest memory module is
corrupted.
An error was detected in BIOS
Flash ROM.
AE01
CPU1_DIMM1 has been disabled.
A memory error was detected.
CPU1_DIMM1 has been
disabled.
AE02
CPU1_DIMM2 has been disabled.
A memory error was detected.
CPU1_DIMM2 has been
disabled.
Contact your sales representative