- 30 -
2) Notice about the function of the System ROM
●
Caution for the “Submit Fail For Form” Question pop-up
If you encounter the “Submit Fail For Form” Question pop-up
while changing the configuration in the System Utilities,
discard the changes by pressing Cancel
. To apply the desired changes after that, reboot the server and re-enter the
System Utilities. Selecting OK to continue the changes may cause some server settings such as Serial Number and
Product ID to be lost.
●
Caution for recovering from a Red Screen of Death (RSOD) screen
If you have changed the server configuration/settings or the system status, a Red Screen of Death (RSOD) screen
appears in rare cases before starting up the OS. This may cause the server to become uncontrollable. However, the server
may recover from the RSOD by turning off and then on the power again.
To recover from this condition, power off and then on the server again.
If the problem persists, contact your sales representative for maintenance.
●
How to recover stop POST by the message of "Memory Initialization Start"
If the server stops POST by a message of "Memory Initialization Start", recover them by setting to the default value by
SW6 of the system maintenance switch.
Refer to “Chapter 1 - 7.3.3 Restore the Default Settings of System Configuration” of the maintenance guide.
●
About UEFI Serial Debug output on BIOS Serial Console
UEFI Serial Debug output could inadvertently be seen over BIOS Serial Console with System ROM v2.32 (03/09/2020).
This issue would be seen periodically on server reboots. POST time will increase by about 2 minutes.
This issue has been fixed in System ROM v2.34 (04/09/2020).
