8000 - Voice Mail
8004 - IntraMail System Options
214
◆
Chapter 3: Programming
IntraMail System Guide
when a user dials
G
while listening to a message.
See the following for more:
■
■
Options
■
1-60
Seconds.
Default
✔
5
Seconds.
Fax Extension
(FAX TRANSFER EXT)
Use this option to specify which system extension is the fax machine. When the Automated Attendant
answers a call and detects fax (CNG) tone, it automatically transfers the call to this extension.
■
Options
■
UND
(Unde
fi
ned, entered by pressing
CLEAR
)
■
Extension number
(e.g., 320).
Default
✔
UND
(Unde
fi
ned, entered by pressing
CLEAR
)
Digital Pager Callback Number
(PAGER CALLBACK NUM)
Use this option to set the
Digital Pager Callback Number
portion of the Message Noti
fi
cation callout num-
ber for a digital pager. This is the portion of the callout number that is appended to the pager service tele-
phone number. Normally, this option should be
X*M#
, where:
-
X
is the number of the extension that generated the noti
fi
cation.
-
*
is a visual delimiter (to make the pager display easier to read).
-
M
is the number of new messages in the extension’s mailbox.
-
#
is the digit normally used by the pager service for positive disconnect.
■
Options
■
Digits
(12 maximum, using 0-9, # and *)
■
M
(Number of messages) (Entered by pressing
MW
)
■
N
(None) (Entered by pressing
CLEAR
)
■
X
(Extension number) (Entered by pressing
ICM
)
IntraMail automatically replaces the
X
command with the number of the extension that initially
received the message.
Default
✔
X*M#
Delay in Dialing Digital Pager Callback Number
(PAGER DIAL DELAY)
Use this option to set the delay that occurs just before IntraMail dials the
Digital Pager Callback Number
portion of the Message Noti
fi
cation callout number for a digital pager. Set this delay so the pager service has
enough time to connect to the digital pager before sending the callback number. Your pager service may be
able to help you determine the best value for this option (
0-99
seconds). By default, this option is 9 seconds.
When placing a digital pager noti
fi
cation, the system:
1.
Seizes the trunk speci
fi
ed.
2.
Dials the user-entered noti
fi
cation number (in
MSG
+
OP
+
N
).
3.
Waits the
8004 - Delay in Dialing the Digital Pager Callback Number
interval.
4.
Dials the number entered in
8004 - Digital Pager Callback Number
.
The system assumes that the noti
fi
cation number will complete dialing approximately 4 seconds after trunk
