Auto Time Stamp
IntraMail System Guide
Chapter 2: Features
◆
41
2
Auto Time Stamp
Description
After a Subscriber Mailbox user listens to a message, IntraMail can optionally announce the time and date
the message was left. The Subscriber can enable Auto Time Stamp from their mailbox, or you can optionally
enable in from system programming. Auto Time Stamp helps if the subscriber needs to know the time and
date of each message they receive without taking any extra steps. With Auto Time Stamp turned on, Intra-
Mail automatically announces the date, time, and (optionally) the caller’s number at the end of each mes-
sage. With Auto Time Stamp turned off, the subscriber must dial
TI
while listening to a message to get the
same information.
Related Features
Auto Time Stamp is available on the Mailbox Options Menu.
IntraMail uses the DS1000/2000 Time and Date.
An extension can listen to a message and dial a code to hear the time the message was sent.
Programming
Step 1
Enable Auto Time Stamp from your Subscriber Mailbox.
1.1
See
Operation
below.
Step 2
Optionally Enable Auto Time Stamp from System Programming.
2.1
1808 - IntraMail Subscriber Mailbox Options:
- Enter
Y
(9) to enable Auto Time Stamp.
✔
By default, Auto Time Stamp is disabled (
N
).
Operation
Turning Auto Time Stamp On or Off
[Super Display Soft Key] - [Keyset Soft Key]
Log onto Subscriber Mailbox.
OP
(67)
Access the Mailbox Options Menu.
[MBOX OPTS] - [N/A]
AT
(28)
Access Auto Time Stamp.
[TIME STAMP] - [TIME]
IntraMail plays a summary of your Auto Time Stamp setting.
-By default, Auto Time Stamp is turned off.
O
(6)
Turn Auto Time Stamp on or off.
[ON] - [ON]
[OFF] - [OFF]
#
Go back to the Mailbox Options Menu.
[EXIT] - [EXIT]
0
Plays Help message.
