English-4
Quick Start
To attach the MultiSync LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2.
For the PC or MAC with DVI digital output:
Connect the DVI signal cable to the connector of the display card in your
system (
Figure A.1
). Tighten all screws.
For the PC with Analog output:
Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your
system (
Figure A.2
). Tighten all screws.
For the MAC:
Connect the Macintosh cable adapter to the computer, then attach the 15-pin mini D-SUB signal cable to
the Macintosh cable adapter (
Figure B.1
). Tighten all screws.
NOTE:
Some Macintosh systems do not require a Macintosh cable adapter.
3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift up to the highest position (
Figure C.1
).
4. Connect all cables to the appropriate connectors (
Figure C.1
).
NOTE:
If connecting both DVI and D-sub cable, the DVI cable must be connected along side the rib on the power cord side
(
Figure C.1
).
5. For successful cable management, place the cables in this order into the cable management: Power cord and DVI cable
(
Figure C.2
).
6. Place DVI cable and power cord into the specific hooks indicated in
Figure C.2
.
7. Place the D-Sub and the USB cable into the specific hooks indicated in
Figure C.2
(USB Cable: NX model only).
Figure A.1
Figure B.1
Macintosh
Cable Adapter
(not included)
Figure A.2
DVI signal cable
Highest
Stand
Position
30˚ Tilt
D-SUB Cable
Power Cord
Figure C.1
(Picture: LCD2070NX model)
Figure C.2
(Picture: LCD2070NX model)
USB Cable
(NX model only)
DVI Cable
Power Cord
DC-OUT
USB
(NX model only)
Input1 (DVI)
Input2 (D-Sub)
DVI Cable
