3
Display Setup
To attach the MultiSync
®
LCD monitor to your system, follow these instructions:
1. Turn off the power to your computer.
2.
For the PC or MAC with DVI digital output: Connect the DVI signal cable (not
included) to the connector of the display card in your system
(Figure 1)
. Tighten all
screws.
For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the
connector of the display card in your system
(Figure 2)
. Tighten all screws.
For MAC setup: Connect the Macintosh cable adapter to the computer, then attach the
15-pin mini D-SUB signal cable to the Macintosh cable adapter
(Figure 3)
. Tighten all
screws.
NOTE: To obtain the MultiSync Macintosh cable adapter, call NEC Display Solutions
of America, Inc. at (800) 632-4662.
3. Place hands on each side of the monitor to tilt the LCD panel 30-degree angle and lift
up to the highest position
(Figure 4)
.
4. Connect all cables to the appropriate connectors
(Figure 4)
.
5. Place DVI cable, D-Sub cable and power cable between bosses indicated in
Figure 5
6. Make sure all cables are resting flat against the stand (
Figure 5
).
7. Hold all cables firmly and place the cable cover onto the stand
(Figure 6)
. To remove
the cable cover, lift the cover off as shown in
Figure 7
.
8. Connect the power cord to the power outlet
(Figure 8)
.
NOTE: If you use this monitor at AC125-240V, please refer to Recommended Use
section of this manual for proper selection of power cord.
9. The vacation switch on the back side of the monitor must be turned on
(Figure 8)
.
Turn on the monitor with the front power button and the computer.
NOTE: The vacation switch is a true on/off switch. If this switch is on the OFF
position, the monitor cannot be turned on using the front button. DO NOT switch
on/off repeatedly.
10. Analog input only: No-Touch Auto Adjust automatically adjusts the monitor to optimal
settings upon initial setup for most timings. For further adjustments, use the following
OSM
®
controls:
• Auto Adjust Contrast
• Auto Adjust
Refer to the Controls section of this User ’s Manual for a full description of these
OSM controls.
NOTE:
For download information on the Windows
®
95/98/Me/2000/XP INF file for
your monitor, refer to the
References
section of this User’s Manual.
NOTE:
If you have any problems, please refer to the
Troubleshooting
section of this
User’s Manual.
LCD1570NXmanual051105.pmd
5/11/05, 1:06 PM
3
