ISSUED: 10-13-05 SHEET #: 055-9445-2 03-31-06
Visit the Peerless Web Site at www.peerlessmounts.com
4 of 7
For customer service call 1-800-729-0307 or 708-865-8870.
Drill two 1/4" (6 mm) dia. holes to a minimum depth of
2.5" (64 mm). Attach projector mount assembly (A)
using two concrete anchors (G), two flat washers (E),
and two #14 x 2.5" wood screws (F) as shown in
Illustration A and 1, 2, and 3 (below). Tighten wood
screws (F) using 3/8" (10 mm) socket wrench until
projector mount assembly (A) is firmly attached.
1
3
Drill hole and insert anchor
Place ceiling plate or mount over anchor and secure
with screw
After repeating step one tighten all fasteners
CUT
A
W
A
Y
VIEW
INCORRECT
concrete
metal
bracket
plaster/
dry wall
CORRECT
concrete
metal
bracket
plaster/
dry wall
FOR DIRECT ATTACHMENT TO LOAD BEARING CONCRETE
ONLY! Concrete expansion anchors are not intended for
attachment to concrete ceilings covered with a layer of plaster,
drywall, or other finishing material. If mounting to concrete
ceiling covered with plaster / drywall is unavoidable, plaster /
drywall must be counterbored as shown below.
concrete
ceiling
F
F
F
Illustration A
Installation to Concrete Ceilings
A
2
A
CONCRETE CEILING
E
G
G
G
G
FRONT OF
MOUNT
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
CAUTION
• Installer must verify that the ceiling will safely support
the combined laod of equipment and all attached
hardware and components.
WARNING
