English-6
Contents
Your new NEC LCD monitor box* should contain the following:
Setup Manual
Power Cord*
1
Video Signal Cable
Base Stand
LCD monitor
(Base Stand not connected)
Setup
Manual
DVI-D to DVI-D
cable
Audio Cable*
2
•
LCD monitor with tilt base
• Power
Cord*
1
•
Video Signal Cable (DVI-D to DVI-D cable)
•
Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male)
• Setup
Manual
• Base
Stand
• Audio
cable*
2
*
Remember to save your original box and packing material to transport or ship the monitor.
*
1
Type of power cord included will depend on the where the LCD monitor is to be shipped.
*
2
E233WM
only.
The model name is on the label.
Rating label on the
back of the display.
Quick Start
To attach the Base to the LCD stand:
1. Place monitor face down on a non-abrasive surface (
Figure 1
).
NOTE:
Handle with care when monitor facing down, for avoiding damage to the front control keys.
2. Please pivot base 90 degrees as shown in
Figure 1
.
NOTE:
Handle with care when pulling the stand.
3. Attach the base stand to LCD monitor and properly lock screw of base stand bottom (
Figure 2
).
NOTE:
Reverse this procedure if you need to re-pack the monitor.
Figure 1
Figure 2
Screw
