English-7
English
3. Place hands on each side of the monitor to tilt the LCD panel 20-degree angle and lift up to the highest position.
4. Connect all cables to the appropriate connectors (
Figure C.1
).
Power cord
20° Tilt
HDMI
Audio Input
Audio Input
D-SUB
Highest
Stand
Position
DisplayPort
DisplayPort
Headphone
Figure C.1
NOTE:
Incorrect cable connections may cause abnormal operation, damage display quality/components of LCD module and/
or shorten the module’s life.
Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor turns down the sound.
NOTE:
Adjustment of the volume control as well as the equalizer to other settings than the center position may increase the
ear-/headphones output voltage and therefore the sound pressure level.
5. To keep the cables neatly organized, place them into the cable management system that is built into the stand.
Place the cables in the hooks fi rmly and evenly (
Figure C.2
and
Figure C.3
).
NOTE:
Cable cover is not removable.
6. Please check that you can still rotate, raise and lower the monitor screen after you have installed the cables.
Figure C.2
Figure C.3
Power Cord
HDMI Cable
D-SUB Cable
DisplayPort Cable
Audio Cable
Power Cord
HDMI Cable
D-SUB Cable
DisplayPort Cable
Audio Cable
7. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet.
NOTE:
Please refer to Caution section of this manual for proper selection of AC power cord.
