English-8
Figure R.1
Non-abrasive surface
Figure R.2
Figure R.3
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm.
Please use the attached screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor
must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor.
The LCD monitor shall only be used with an approved arm (e.g. GS mark).
NOTE:
The mounting stand must be able to sustain at least 20 kg and be UL certified.
Replace screws
Tighten all screws
100 mm
100 mm
Thickness of Bracket
(Arm) 2.0 ~ 3.2 mm
Remove Monitor Stand for Mounting
To prepare the monitor for alternative mounting purposes:
1. Disconnect all cables.
2. Place monitor face down on a non-abrasive surface (
Figure R.1
).
NOTE:
Handle with care when monitor facing down, for avoiding damage to the front control buttons.
3. Remove the 4 screws connecting the monitor to the stand and remove the stand as indicated (
Figure R.2
).
The monitor is now ready for mounting in an alternative manner.
4. Connect all cables to the back of the monitor (
Figure R.3
).
5. Reverse this process to re-attach stand.
NOTE:
Use only VESA-compatible alternative mounting method.
NOTE:
Handle with care when removing monitor stand.
Control buttons
4-SCREWS (M4)
MAX depth: 9.5 mm
If use other screw,
check lenght of screw.
Weight of LCD assembly: 5.0 kg (MAX)
Specifications
