English-19
English
POWER SAVE TIMER
POWER SAVE TIMER allows the monitor to turn off automatically after continuing power saving mode for 2 hours.
LED BRIGHTNESS
You can adjust the blue LED brightness.
DDC/CI
This function allows the DDC/CI function ON or OFF.
USB POWER
Selects a power relation of USB.
AUTO:
Power is supplied to USB downstream port depending on related power condition.
ON:
Power is always supplied to USB downstream port even when in power save mode or power OFF.
NOTE:
Power consumption depends on connected USB even when a monitor’s power is off.
180° ROTATE
Select to display the image for 0°
or 180°
.
FACTORY PRESET
Selecting Factory Preset allows you to reset all OSD control settings back to the factory settings except Language and
OSD Lock Out. Individual settings can be reset by touching the “ECO/RESET” key.
MENU Tools
LANGUAGE
Selects the language used by the OSD.
OSD TURN OFF
The OSD menu will stay on as long as it is in use. You can select how long the monitor waits after the last key touch to
shut off the OSD menu. The preset choices are 10-120 seconds by 5-second increments.
OSD LOCK OUT
This control completely locks out the access to all OSD control functions except for Brightness, Contrast and Volume.
To activate the OSD Lock Out function, enter the OSD menu, select OSD LOCK OUT, then touch “SELECT” and
RIGHT simultaneously. To deactivate, touch “SELECT” and LEFT simultaneously.
HOT KEY
When this function is activated BRIGHTNESS and VOLUME can be adjusted without entering the OSD menu by using
the front keys.
ON:
The “ECO” touch key on the bezel is enabled and can toggle among ECO settings.
The Up/Down key adjusts the VOLUME and the BRIGHTNESS level.
OFF:
The HOT KEY function for “ECO” and “Up/Down” functions are disabled.
SIGNAL INFORMATION
If you select [ON], the monitor displays “VIDEO INPUT” after changing the input.
NOTE:
The compliance marks that are shown when powering on the monitor the first time are not shown when
switching inputs.
The compliance marks are not shown again unless the AC power cord has been disconnected at the
power off status and reconnected.
If you select [OFF], the monitor does not display “VIDEO INPUT” after changing the input.
NOTE:
Setting [OFF] also prevents the compliance marks from being shown when powering on the monitor.
SENSOR INFORMATION
If you select “ON”, monitor displays “HUMAN SENSOR ON” message. If you select “OFF”, monitor doesn’t display
“HUMAN SENSOR ON” message.
KEY GUIDE
If you select “ON”, the Key Guide appears on screen when the OSD menu is accessed.
